Hello,
We would love to begin work ASAP on your project but have a few questions.

A) what is the size of the bucket
B) what information do you want on the bucket
C) do you have a vector logo
D) is the base color of the bucket

Please contact us via email if you have any questions or us. Thanks!

-3lbcreative.com

A) there are two sizes 5L and 20L. The print die lines are:

5L bucket - 545 x 202 mm print gap 6mm
20L bucket - 838 x 258 mm print gap 30mm

B) Info as provided in the brief for the front of the bucket. For the back of the bucket should have the following information displayed:

XXXX Contractors Trade Acrylic is an economical waterbased paint for interior and exterior use

Application

Stir well before use
Use a roller or a brush
Overcoating time is 1 hour at 23 degrees Centigrade
Clean equipment with water
Note: Icons would be great for this section

Surface Preparation

-All surfaces are to be sound, clean, dry and contamination free.
-Masonry (Cement Plaster, concrete): Porous and friable surfaces are to be sealed and bonded with O'Grady's Plaster Primer or O'Grady's Bonding liquid prior to application of any coating.
-Gypsum Plaster, Gypsum Board, Unglazed Brick, Hardboard, Fibre Cement: prime with O'Grady's Plaster Primer

Previously coated walls in good condition:
-Waterbased - Use O'Grady Sugar soap solution or Superclean then rinse with fresh water and applying XXXXX Contractors Trade Acrylic
-Enamel: Use O'Grady Sugar soap solution or Superclean then rinse with fresh water. Sand thoroughly to an even matt finish. Dust off and apply O'Grady's Universal Undercoat. Observe overcoating times and then apply XXXX Contractors Trade Acrylic

Previously coated walls in poor condition: Strip paint completely using O'Grady's Paint Stripper and proceed as for new surfaces

-Distemper and Limewash: Remove completely, seal with O'Grady's Plaster Primer
-Chalky Surfaces: Remove as much of the chalk from the surface as possible. Seal with O'Grady's Plaster Primer or O'Grady's Bonding Liquid thinned with O'Grady's Mineral Turpentine

DO NOT APPLY TO BARE METAL SUBSTRATES

For additional information always refer to the Techinal Data Sheet prior to appliation. Available from www.ogrady.co.za

Safety

Keep out of reach of children
Ensure good ventilation whilst applying
Skin Contact - rinse with soap and water
Eye Contact - rins with plenty of water
If swallowed, do not induce vomitting

Always seek medical advice

For any queries please contact O'Grady's Technical Advisory 086 722 7867

Manufactured by O'Grady Coatings Group (PTY) Limited
30 Celcius Street, Middelburg, Mpumalanga

20L (Note: in a distinctive block)

C. What is a vector logo?

D. the base colour of the buckets is white

Hello,
Thanks for your speedy response. We will begin work ASAP. A vector logo is the original logo file from whoever designed it. We can use the logo on the website but the quality will not be that great. Thanks!

-3lbcreative.com

sorry I don''t have a vector logo - it was designed ages ago and can''t remember who did it.  How do we go about ensuring that the quality is good enough?